Steps for installation

1. Clean your chainstay to get rid of all the dirt, oil and grime. This is essential so that the protector can stick to the surface properly
2. Peel off the backing paper of the chainstay protector and carefully place the chainstay of your bike
3. Apply pressure from all sides to ensure it is stuck properly

Things to keep in mind during Installation 

1. Ensure that the Chainstay is clean and has no dirt, oil, water or grease before installation
2. Peel off the red transfer paper carefully as the gum can be soft before installation 
3. Apply pressure after installation
4. If possible use zip ties to tie down the chainstay protector for around 2 weeks 

 Note: Be careful while removing the transfer paper during installation, the gum is soft as it is meant to adapt to your bike frame.