To achieve a flawless, bubble-free application of your Clear Frame Protector Kit, follow these expert tips

1. Ensure a Clean Surface: Before installation, thoroughly clean the bike frame using a gentle, non-abrasive cleaner. Make sure the surface is completely free from dirt, oil, or grease to maximize adhesion.
2. Customize for Cable Routing: If your bike frame includes internal cable routing, measure and carefully cut the frame protector to fit around the cable holes. This ensures full protection without compromising functionality.
3. Adjust the Length: Trim the protector to the required length before applying. This step prevents excess material from wrinkling or misaligning during installation.
4. Apply Gradually: Start by peeling a small section of the backing and aligning it with the frame. Press the adhesive down gently and continue peeling back the liner as you apply the protector a little bit at a time.
5. Remove Air Bubbles as you go: Use the included squeegee or your fingers to push out air bubbles from the center toward the edges. Applying even, firm pressure ensures a smooth, clean finish.
6. Double-Check Edges: Once applied, run your finger or a soft tool along the edges to secure the adhesive, ensuring it won’t lift over time.

These steps will help you achieve a professional-looking, long-lasting frame protection that keeps your bike safe from scratches and wear. For more assistance, contact our support team, we're here to help!